How To Repair Gelcoat Chips

boat-vinyl.jpg

Want your boat to look new? Most of that “like-new” look
depends on the gelcoat. That means you’re going to need to take care of it. To
do that, you’ll need a great routine for cleaning and waxing your boat, and you
need to understand what to do if some of your gelcoat chips off. The good news
is that it doesn’t have to be difficult. Here’s a quick guide to teach you how
to repair gelcoat chips.

Why You Should Care About
Your Gelcoat

The quality of your boat’s appearance is largely the result
of its fiberglass. If the fiberglass gelcoat is damaged, dinged or chipped,
it’s going to throw off the entire smooth exterior. Left unchecked, these
issues can even spread to surrounding areas. It may not seem like it now, but
the best way to ensure a quality appearance for your boat is to repair gelcoat
chips as soon as possible.

Keep in mind that the gelcoat is the first line of defense
between your boat and the marine environment. It’s essentially the boat’s
“skin.” If you don’t take care of it, it will affect the entire appearance and
even performance of your boat.

Gelcoat Chip Repair
Guide

Keep in mind that if you have light damage, such as chalking
or fading, you can easily use a bottle of Color
Restorer
without going through these steps. But if your fiberglass damage
is more serious, it’s important not to skip them.

Find The Right Color

Your gelcoat has a specific color, so it begins with
matching your repairs to that color. According
to Boating Magazine
, you’ll need to be careful here, as the rest of your
original gelcoat color may have faded with time. That’s why it can be a bit of
a chore to find the right match—and why it’s so important to take steps to
prevent this UV fading over time.

Clean Edges Of Chip

Your next steps will be to clean up the edges of the damaged
area using a rotary grinder. Feel free to scrape away other debris here,
including old sealant, so that you can apply a smooth, consistent layer of gelcoat
later. It’s better to do this work sooner rather than later—and it’s especially
important to handle all of the repairs at once, while you have the equipment
ready and the boat out of the water.

Apply The Gelcoat

Tape off the area and mix the gelcoat. Then, once you’re
sure you have a thoroughly mixed gelcoat ready for application, put it on. The
tape will ensure that you aren’t adding more gelcoat to surrounding areas. After
mixing, you’ll have a window of about 10 or 15 minutes with which to work. When
you’re done, spray it with a PVA curing agent.

Final Steps &
Post-Repair Wax

Now you have the option to sand it down and peeling off the
PVA to apply the wax. BoatLIFE offers a number of high quality boat waxing products
to ensure a properly-protected gelcoat for years to come. Use these wax products
to prevent future repairs and keep your boat looking its best.

Leave a Reply

All products proudly made in the usa

Download Catalog