How to Check & Repair Your Boat’s Transom



Even when you inspect your hull regularly, there’s one area
of your boat that can often get overlooked: the transom. New boat owners aren’t
even aware that the surface of their boat’s stern even has its own name. But if
you want your boat to look its best, checking and repairing the transom is
essential. But that still leaves one question: how do you check and repair
transom issues on your boat? Here’s a simple guide to help.

Add a Transom
Inspection to Your Boat Maintenance Routine


When you look over your boat’s hull for problems, never skip
the transom. Even if the thought of trying to fix a transom issue fills you
with dread, you’ll always do better if you spot an issue sooner rather than
later. Usually, a problem with the boat transom
does mean you’re in for either a costly or a labor-intensive
repair—or both.


For example, repairing an outboard on your boat transom can
mean removing the transom top, removing any associated fixtures, digging out
bad and rotted wood, letting the interior dry, treating the area, and
re-assembling. If it sounds like a lot of work, that’s because it is.


Because problems like rot frequently plague boat transoms,
you’re going to need to regularly inspect the transom for rot problems
specifically. The good news is that there are dedicated products to help treat
this kind of boat rot.

Git-Rot: An
Alternative to Hard Work & Expensive Repairs


What if there were an easier way to repair rotted wood out
of a boat transom without the extensive labor and expenses?


There is. Git-Rot is a two-part
liquid epoxy designed to fill and restore wood back to its original strength by
treating the rot at its most problematic points. By injecting Git-Rot directly
into the wood, you bypass all the disassembling and reassembling of transom
repair and treat the problem at its source.


This isn’t to say that Git-Rot will require absolutely no
work at all. There are a few
best
practices
to treat your transom wood:


  • Wait for the ideal temperature—between 50 and 70
    degrees Fahrenheit. At about 70 degrees, the applied Git-Rot will solidify
    overnight, boosting the wood’s strength.
  • Inject the Git-Rot into the wood’s end grain
    whenever possible. Think of Git-Rot like blood moving through capillaries: in
    order to reach the most wood, it has to sink in and move around with the wood’s
    fibers. By seeking out end grain, you have more direct access to the wood’s
    interior, which boosts the performance of Git-Rot.
  • Inject into dry wood. While Git-Rot will
    eventually cure even in damp wood, it works much better in dry wood, as the
    epoxy solution will move around more freely and better saturate the wood.

Final Thoughts


The transom on your boat is like the caboose on a train:
it’s all anyone sees after you’ve passed. Regularly inspect this area, apply
Git-Rot when needed, and you’ll go far in extending the life and quality of
your boat.

Leave a Reply

All products proudly made in the usa

Download Catalog