Adding A Boot Stripe to Your Boat

Your boat might look 99 percent perfect. But no matter how
much you wax it and clean it, there might be something about its appearance in
the water that just seems—for lack of a better word—“off.” For many boat
owners, the final step is simple: a boot stripe. A boot stripe accomplishes
more than just adding a dash of color to your boat. This narrow stripe spanning
the entire length of your boat will give it a “finished,” well-rounded look.
Adding a boot stripe to your boat is easier than you think. Just use this
simple guide!

Painting a Boot
Stripe or Adding Vinyl Striping

Before you even think about how the boot stripe will look,
you have to make a decision. Are you going to paint the stripe on, or will you
add a pre-made vinyl stripe with adhesive?

For beginners, the vinyl striping will be a little easier
and contain fewer steps. It’s true that painting on a boot stripe will give you
some more control over its ultimate appearance, but there are plenty of vinyl
boot stripes out there that should suit most aesthetic needs just fine. For the
remaining steps here, we’ll assume you’re attaching a vinyl stripe that’s
backed with adhesives.

Prepping Your Boat

Before you get started, you’ll want to check each of these items
off your list:

  • Choose the color of your boot stripe.
  • Find your boat’s waterline. Your boot stripe is
    intended to go just above this line.
  • Clean, rinse, and dry the boat hull before
    working to ensure you get a proper adhesion. You should also apply a boat-friendly
    solvent
    to ensure that a wax coat is done away with, allowing the adhesive
    to stick directly to the hull.

From here, you’ll want to get to the next step: planning the
actual location of the tape. Apply something easy to remove, such as painter’s
tape, of equal width to your vinyl stripe. You can then apply a strip of
painter’s tape on either side and remove the center stripe to give you a basic
outline of where your vinyl will go.

Applying the Vinyl
Adhesive

It’s tempting to work in small pieces when adding a boot
stripe to your boat, but you’ll get a smoother appearance out of your vinyl if
you peel it off as much as 4 feet at a time. You can then grip it well, even
stretching it a little bit, to ensure that the vinyl stripe looks smooth on the
exterior.

After you’ve finished, you can make adjustments carefully using a
small blade—or simply let the vinyl adhesive set.

Use the Right
Products

Need help along the way? Use specialized BoatLIFE products
like Release
Adhesive and Sealant Remover
to remove any old adhesive before applying your
vinyl stripe. We have plenty of Boat Cleaners
as well to help ensure that, once dry, your boat hull and vinyl adhesive will
stick tightly together, giving you a boot stripe that will endure for years!

Leave a Reply

All products proudly made in the usa

Download Catalog